...The drum should be on center. It sound like a damper pads issue. The damper pads are located beneath main support housing on base's machine. Check that they are on place and not broken. Good luck
...damper pads on a Maytag a710 washer How do I remove and install new damper pads on a maytag a710 washing machine? by damper pads you mean three curved felt pads that come in one package.if yes yes i ...
Question about Legacy Top Load Washer
...Damper pads, P/N 203956, $23 at searspartsdirect.com might do the job. Can't put them in yourself though, unless you are the Maytag man. Look for felt pads at the bottom of the cabinet or black dust ...
...damper positions. There should be at least three such dampers, maybe more, and they can be several types from friction pads to tiny automotive-looking shock absorbers. If the tub seems offset to one ...
...damper pads beneath the main support housing on the of the base of the washer. If the tub does not recenter or if the machine machine vibrates to much, replace the damper pads. If the tub leans too ...
...kit? they are to stop the vibration from the rotor to the pads to the foot pedal. not so much of a shim as a vibration damper. most have a sticky side on them so check for it first before
water runs over the pad and air pulls moisture off the pad. Putting it into the home. Make sure the damper is open for proper air flow
...damper pads. Remove the old damper pads using rubbing alcohol or other solvent and remove them from the machine. Use a utility knife or razor to assist in removing the old pads. Use a clean cloth to ...
...made an impact on the temperature reading. Any suggestions? You may want to check your damper assembly to see if the door is broken. If the door is broken it will air to migrate to the ...
Could this problem be something other than the discs and pads? Did the installer use the wrong size dampers? Bad wheel bearing
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions