Questions & Answers for: cut wood angles

...ceiling pitch is 12/6. Can I purchase a different hanger bracket to accommodate my ceiling angle? I removed a Generic ceiling fan from this same location and had no angle issues. cut a wood

the position of the guide rollers, and the condition of the blade are all important to get a straight cut. You might want to try lowering the guide rollers down close to the wood being cut. good luck

...cut into it at pre determined angles. ie 45 degrees. When cutting a mitre joint the wood is placed against the block and the saw follows the line of the slot cutting the 45 degree angle. Hope this ...

...torks when I try to cut hard wood or 2 in. wood. There shoul be a scale and a crank or screw used to adjust the blade angle on the front of the saw blade feed bushing. Make sure you set this to ...

...Use this distance to mark another line parralel to the first line. Nail or screew a straight piece of wood on the second line. Put the jig-saw plate against the wood fence and cut your perfect

...cut mostly hard woods, oak, hickory etc. I just replaced the bar and chain and it still cuts crooked at an angle leaving grooves in the wood. Any ideas Have the chain professionally sharpened (Stihl ...

cut through a 3/4 inch piece of wood is terrible. I am sure it is a tension issue but I do not know what to do to correct it. Your assistance would be appreciated. This is a common issue with jig saws

wood , if one changes the cut angle on teeth the rake teeth might not do there job correct and saw bogs and "files" thru wood rather than chips thru wood ,takes longer ,more fuel, more effort , a look

...wood moves and the cut angled and I do not it to? I have a jigsaw that when I cut with it the plate you put on the wood moves and makes the cut angled when I do not want it? its a black and decker ...

How to cut a 45 angle wood I would use a protractor and mark my angle before offering the saw to cut.