...the washer nozzle ball. 3.If the amount of washer fluid is too small, check for clogged, bent or crushed washer piping. Check the chipped points too, because the tube might be
...filter requires four washers, one on each side of each pipe connection). Used washers are already crushed and so require more torque to seal. Usually just tightening the hex fitting more will make ...
Question about Neptune FAV6800AW Top Load Washer
Fixed the clutch. Now has a rock crushing sound when spin starts I removed and cleaned and lub'ed the clutch and the bearing. Washer worked "OK". Now the washer has a rock crushing sound I think when ...
...crush washer on the injector. while you could try toghtening the banjo bolt (if the leak is coming from around the hose area), the solution will most likely be to get a new compression bushing or ...
...crush washer that goes beneath the bolt in the oil drain pan needs to be replaced - some times after an oil change a mechanic might over-tighten that bolt and damage the crush washer too much. The ...
...crush washer behind it. Hold the bike straight, pull that bolt out and fill with oil slowly. Once a good solid amount of oil comes out, install that bolt with a new crush washer. Chaz- Moto DC mine ...
...new oil pan Basically oil pan plug is nothing but a bolt with crush washer. Buy the bolt of the same no. as the old plug one and new crush washer with it. Just make sure you buy a good quality
Crushed ice doe not work Good Afternoon Friend, I understand that the ice maker on your Frigidaire refrigerator is not crushing the ice. I suggest resetting your appliance, by either unplugging it or ...
Question about 2005 Colorado
...crush washer to seat the bearings,,, after the crush washer is seated i believe it 100 foot pounds,,use a little red lock tight if its a used nut,,,setting up a rearend is a complecated and time ...
Question about 2005 Colorado
...crush washer, seat the plug, then tighten to 1 0-1 5 ft. lbs . (1 4-20 Nm) or about 1/4 % turn to crush the washer. Whenever possible, spark plugs should be tightened to the factory torque ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions