...position don't worry it will fit. But if you install from the dealer. I recoment check the engine for high vibration. Check the crankshaft for end play. And check the wires from the sensor for short, ...
crankshaft position sensor located where on a altima 2005 2.5 4 cylinder hi The crankshaft position sensor (POS) is located on the cylinder block rear housing facing the gear teeth (cogs) of the ...
...the crankshaft position sensor?? and it goes in to the transmission right above the drive shaft. thanks it realy help after all day?? where is the crankshaft sensor located on a 1996 nissan ...
Question about 2003 Altima
...crankshaft position sensor on a 2003 altima it is very hard it is very hard!!! get some needle nose pliers or a seal pick to disengage the lock on the plug and then pull the plug loose with a small ...
Crankshaft Position Sensor Error P0335 recurred after r&r Replaced the Crankshaft and camshaft sensors as a kit from Nissan. Cleared all codes (only code was P0335) and car was hard to start then ...
...solenoid valve may be faulty - Crankshaft position sensor (POS) may be faulty - Camshaft position sensor (PHASE) may be faulty - Accumulation of debris to the signal pick-up portion of the ...
...crankshaft position sensor? The crankshaft position sensor is located at right hand side of rear eng block by bell housing. Its easy to see by removing top eng cover look down thru the gap between ...
...crankshaft position sensor and vehicle speed sensor). He also recommended a mechanic who would charge about 155.oo to install these parts.They recommended a transmission flush for 120.00,but I read ...
Question about 2005 Altima
crankshaft position sensors in my 2005 altima also the o2 seneor car still will not run. error code 335 What else could be the problem? DTC P0335 - Crankshaft Position Sensor A Circuit Malfunction The
Question about 2005 Altima
crankshaft position sensor and attempted to install new aftermarket sensor. Could not get it in position. Bought another aftermarket brand CKP sensor, same result. Removed camshaft position sensor and
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions