Questions & Answers for: crank sensor location 2004 hyundai

...crank postion sensor. how do I remove the crank position sensor if you have the 2.4l it is located behind the timing belt on the crankshaft. possible causes include timing belt teeth seperated or ...

...crank sensor is a component used in an internal combustion engine to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control ...

...crank shaft sensor is located in the 2004 hyundai santa fe so that i can change it. Which engine?? V6 or the 2.4I? The V6 CKP is in the engine block near the flywheel side of the engine (behind and ...

...sensor is so i can either replace it or make sure it is properly connected On the 2.4 liter 4-cylinder, it's located at the front of the engine at the crankshaft,.. on the 2.7 V6, it's located on the ...

...Crank shaft sensor changed and then it worked for 2 weeks only to cut off completely now. All diagnostics show nothing is wrong. Service shop is out of solutions and I am out of a car and have to be ...

...Crank sensor Crank sensor defective bad. Where is it near by?Timing belt? Hi On the 2.7 engine it is located beside the starter. You will have to remove the starters heat shield to gain excess to the ...

...crank sensor is used only for misfire detection and NOT spark timing (this varies with the vehicle), the vehicle should start and run with MIL (Malfunction indicator lamp) illumination. Also, some ...

...crank position sensor is malfunctioning your probably seeing an engine fault light and it is possible it is running roughly. This can cause severe damage to the motor if you continue to use the ...

2004 santa se 2.4L Temp gauge reads normal, but heat from vents excesivlly hot.will not start after running for a while until it sits 1/2 hr. always starts cold. does not do it all the time. no ...

...crank sensor failure. You probably have a check engine light on. I would suggest checking that code. Crank sensor replacement is fairly easy, remove lower engine cover underneath, 1 10mm bolt holding ...