...crank sensor intrechange with 2006 chevy equinox crank sensor Looking at the books the cut off was at 2005, up till this year the parts would interchange. Also due to the way GMC does things your ...
No Spark bad crank shaft sensor or bad coil pack/ecm
crank sensor, camshaft position sensor, or knock sensor. If its not on its most likely a over heating coil or a bad ignition module. Another possibility is going to be the fuel pump going bad. However
...Monte Carlo Z34. We replaced the turn signal switch and had to replace the power steering pressure hose. Now the car will not start it will crank but no fire. Any ideas or suggestions? It was running ...
...sensor, the BCM sends a class 2 serial data password to the PCM in order to enable the crank relay and fuel injection system. The PCM then allows the vehicle to start normally. FUEL LOCKOUT CYCLE The ...
...start after driving awhile. Do a wiggle on the CKP (crank position sensor) this sensor is located at the front main engine pulley, I am seeing a lot of loose male to female connection shut car
TRACTION CONTROL AND ABS LIGHT COMES ON Noise at start, abs light and traction light comes on normally when turning and just starting to drive it. I have replaced the front two hubs in the car, Midas ...
changed engine now have no spark Check to make sure all your connections are tight and especially crank sensor.
Question about 98 99 Chevy Lumina Monte Carlo 3.8 3.8l Fuel Injectors
...Crank Sensor With a Multimeter troubleshootmyvehicle.com > GM > 3.8L Oct 24, 2011 - The 3X-18X crankshaft position (crank) sensor, on the GM 3.8L V6 engine, can easily be tested (to find out if it's ...
Question about 98 99 Chevy Lumina Monte Carlo 3.8 3.8l Fuel Injectors
...and has no spark.what more must i do to get it to start. replaced crank sensor ,coil packs ,and checked fuses and good. Is the security light on? If so, there's a problem with the antitheft
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions