Questions & Answers for: craftsman table saw motor repair

...Craftsman table saw with a burned out motor. The motor model number is RM871. Where can I find one for less that the $130.00 that Sears wants for the motor. That's the price of the saw. SOUNDS LIKE ...

...Craftsman table saw. The motor has the number RM871 on it. It is a 15 amp, 5000 rpm motor. Sears wants $141 for a replacement motor and I only paid $150 for the saw new. The rear bearing in my motor ...

motor seized brushes were tight took off cover on motor rear bearing no good can i replace it and how Check www.searspartsdirect.com to see if part is available.  Parts diagrams are also there so

...craftsman table saw model rm871 Go to midlandhardware.com.For about $4.00 more than just price ofthe motor,you get the complete saw 15amp.motor with a laser guide!The table saw has a 3yr. warranty,3 ...

...Craftsman 10" table saw model # 11329992 10. (1955 motor) I'm thinking I need to look for replacement motor. How can I identify frame number? Spoke to Sears Parts Department, they no longer carry ...

...Table Saw runs very smoothly for 20 minutes to 1/2 hour, then slowly stops as though it had been shut off. Sometimes clearing sawdust and debris from around the motor cools it enough to restart. This ...

...motor part # 63870 for a 10-inch sears radial saw There may be a recall on this model. http://www.radialarmsawrecall.com./ If not, take the motor out and take it to a shop that does repairs on ...

Craftsman 8'' direct drive table saw only hums I have a Craftsman 8'' direct drive table saw model 113.221620. It was working fine, but this time when it was turned on the motor only hums. Any ...

...Craftsman 10" table saw, probably at least 50 years old. The motor is dying, model number 113-12070. Where can I get this motor repaired or replaced? I would go to the nearest electrical company and ...

...craftsman 10" table I have an older craftsman 10" direct drive table saw. The saw will not start on it's own, the blade tries to spin but can't get up to speed unless I, sounds crazy, "kick start" it ...