...craftsman 18 inch chainsaw starts and runs fine for a few minutes then dies hard to restart close chock it will restart open chock and it will start and again die after a few minutes. any ideas Try ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
Chainsaw runs but when I start cutting it dies I have a STIHL 026 that starts fine but when I start to cut wood it strugles and then dies. you might just neet to clean the air filter and/or the carb.
Question about Craftsman 36cc, 16 In. Gas Chain Saw
Craftsman chainsaw model number 358.351610 worked ok yesterday. Today it starts, runs then dies when trying to cut. Is there an adjustment I need to make? there is two adj screws on the side of the ...
Craftsman 2.5 Turbo 18" chainsaw. Yesterday it would start and run briefly and the die. I changed the sparkplug and cleaned the air filter and now the saw will not start. The plug is generating a
Question about sears 18" Chain Saw Chain ( Model 35084 )
...chainsaw will start on choke but dies when you give it gas You need to strip and clean out the carb. The main fuel passages and jets are blocked or stuck. A new gasket set would probably also not be ...
Question about sears 18" Chain Saw Chain ( Model 35084 )
craftsman chain saw 358.350870 starts but will not continue to run engine starts but then dies after about 30 seconds. replaced air filter, cleaned carb, replaced rotted fuel line (inside fuel tank) ...
Question about sears 18" Chain Saw Chain ( Model 35084 )
Model # 358.350990 ... saw died while cutting...found small blue rubber plug with star washer... loose in bottom of fuel tank ...reattached to only line in tank it could go to... still hard to start ...
Question about sears 18" Chain Saw Chain ( Model 35084 )
...craftsman starts and runs great,but when I start cutting it dies. it's new ran 1 gallon of gas through it. Does it help if you keep the choke closed about half the way ? If it does check for a bad ...
Question about sears 18" Chain Saw Chain ( Model 35084 )
...craftsman chainsaw 18 inch, with 42 ml engine. The problem is when you finally get it started, it dies when you give it gas. I need an answer please? I see this problem a lot, so I just decided to ...
Question about sears 18" Chain Saw Chain ( Model 35084 )
...craftsman 3.3ci chainsaw when started it runs very high on choke but when I depress the choke switch in the saw dies but will run fine when choked I've cleaned the carb replaced the fuel lines an ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions