...auger shaft turns, check your shear pins again. Sometimes they will break but still stay stuck in the holes. Actually take one out and check it. If it is a Craftsman you can get a manual from ...
Question about Garden Tractor Snowblower Mounting Kit (Craftsman)
...auger housing. (Most units you can do this, but be careful, not all do). Then, remove bolts that hold bottom plate on snow blower, and remove bottom plate. If you follow the shift linkage down from ...
...Craftsman 536.886260 shear bolts stuck - rusted to shaft. auger won't turn. any advice on how to remove? I have used several types of penetrating oils (wd40, liquid wrench etc.) any advice will be ...
Question about Garden Tractor Snowblower Mounting Kit (Craftsman)
...Craftsman 536.886260 shear bolts stuck - rusted to shaft. auger won't turn. any advice on how to remove? I have used several types of penetrating oils (wd40, liquid wrench etc.) any advice will be ...
Question about 22" 179cc* Dual-Stage Snowblower
... checked the shear pins & they are ok. check for bent blower and auger blades check rear blower bearing, engine off( grab rear of shaft pull up and down) shouldnt move very much. if it does bearing ...
Question about 22" 179cc* Dual-Stage Snowblower
Craftsman 536.886260 shear bolts stuck - rusted to shaft. auger won't turn. any advice on how to remove? I have used several types of penetrating oils (wd40, liquid wrench etc.) any advice will be ...
Question about 22" 179cc* Dual-Stage Snowblower
auger's shaft (my craftsman has one on each side), and the one on the side that stops turning is sheared off. (It moves without snow present due to the driveshaft inside the outer auger shaft turning,
Question about Snow Blower / Snowblower Bottom Cover :
...on the auger and use a low-temp grease to service those fittings. Lastly; behind the auger is the impeller shaft. Reach in and see if it wiggles. If it does, then have your impeller bearing
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions