Question about Rand 271 Super Duty 1 Inch Pnuematic Impact Wrench
air impact tool does not engage but will eventually engage after switching directions. I have a standard duty 1/2" Craftsman pnuematic impact tool. problem is it seems to not engage in gear, however ...
Craftsman 30'' mower front tire off rim can't put back on hello...is the tire loose but still on the rim...the sidewalls no longer engage the rim tight to hold air but still aroung the rim loose....If
...ratchet works but i have play with the air hose on and off to use it. i oil it. sounds as if it needs servicing ,not expensive -----what do you oil it with ? if you dont have the correct oil use auto ...
Question about 3/8" Pro Air Ratchet Rapid Reverse 19888
...craftsman 3/8 ratchet. air pressure set at 80pi. add a few drops of marvel mystrey oil to the ail line opening to clean it out and try it again Low Torque? I used to overhaul other Technician's air ...
Question about 3/8" Pro Air Ratchet Rapid Reverse 19888
...ratchet freely with a wrench but when I add air line to them they dont seem to work they do nothing, maybe they are froze up , need oil ? Or are they Junk? Is blue point a snap on brand, maybe ...
...Craftsman 3/8" air ratchet (875.199190) just quit working this week and is blowing air out the side of the motor housing. It's only 6 years old, but has been working well for me. I can get it ...
...air, don't go out and rent an electric impact wrench. Waste of time and money. If you can get a box end wrench on it use that as box end wrenches are less prone to slip. Get a quality socket, like a ...
...air compressor capable of generating 900 ft. - lbs. of torque. OR I have cheated with this by using a Craftsman 1/2" drive ratchet and 6 sided socket. (Fortunately the engine I was working on turned ...
...air ratchet does not work. Head will not turn and air comes out of breathing vents, like it seized up I put some lubrication oil into the air line then made sure that it goes in there by moving the ...
craftsman 3/8 ratchet model 875-188020 no power Check the O-rings in the rachet, itf they are leaking then the rachet will not work.
Usually answered in minutes!
317 Questions
162 Questions
122 Questions