Questions & Answers for: cost changing motor mounts 2002

...sebring changed fuel filter,o2 sensor,computeramd idil motor.IT wasstalling all the time but after i put in the idiling motor it stopped stalleing but now revs very high at almost 3000 rpms i checked ...

...sebring lxi my 98 sebring lxi when i trun left of right the flasher works fine but when driving the flasher will not stop ticking as if i had a brunt out lightbut goes normal when i make the trun can ...

motor mounts and struts replaced in my 2001 Chrysler Sebring LXI coupe. The negative battary cable was disconnected for a few days and when i started the car it was dead.I had my alternator tested its

...2002 Chrysler Sebring LXI that the automatic door lock inside on driver side quit working, but my remote unlock does work, and also, my windshield washer will not dispense, I have filled it up, but ...

...2002 Chrysler Sebring LXI. The car shuts off whenver I apply the brakes or will not idle. This always happens after a power failure, such as changing the battery. After a period of the time the ...

2002 sebring lxi conv 2.7L. I've changed the cam and crank sensors.i am getting fuel and i do not have any trouble codes showing. what else can i check sounds like ur starting fuse main block is blown

...sebring 2002 lxi might be too small to read here since FixYa limits insert files to 150k however, you can go an auto parts store like Autozone and buy a good electronic service manual specif for your ...

...2002 Chrysler Sebring LXI coupe and the car runs great when it stays running. When I shut the car off and start it back up it just starts and dies but if i unhook the battery the hook it back up and ...

2002 Chrysler Sebring LXi. Chrysler Sebring Questions - Engine Power Loss After Car ... www.cargurus.com > Questions > Chrysler > Sebring CarGurusNov 3, 2011 - Engine Power Loss After Car Is Warmed Up

...2002 Sebring lxi 3.0 two dr coupe ? looking for bank 2 sensor 2 location on a 2002 sebring lxi 3.0 2dr coupe? This should be the O2 sensor on the passenger side, after the converter. Its job is to ...