Questions & Answers for: correct flame gas dryer

Question about Dryers

1 Answer

...correct such problems by adjusting the air shutter on the gas burner, which is located along the bottom of the dryer. To adjust the shutter, take out the screws and remove the panel that covers the ...

Ad

Question about Neptune MDG5500AW Gas Dryer

2 Answers

...gas. It will heat and dry for a while and the flame will go out. The igniter will glow again after awhile but the flame will not come back on and the dryer keeps running and running. If I stop the ...

Ad

...flame comes on but off in about 20 seconds then comes on again but dryer doesn't get hot enough. Can you suggest what it may be. Is there a sensor for wetness that may not be working. Jeff since you ...

...correct such problems by adjusting the air shutter on the gas burner, which is located along the bottom of the dryer. To adjust the shutter, take out the screws and remove the panel that covers the ...

...out, which turns off the gas and flame at this time. firstly..is venting blocked? disconnect venting and try it. if problem persists then replace hi limit. assuming what you just told me was

gas does not light then the flame sensor may have to be replaced. If the gas ignites but does not stay on either the flame sensor or the coils are at fault. See also: http://home.howstuffworks.com/how

Question about RGX4634KQ Gas Dryer

1 Answer

gas does not light then the flame sensor may have to be replaced. If the gas ignites but does not stay on either the flame sensor or the coils are at fault. See also: http://home.howstuffworks.com/how

Question about LGB6300 Gas Dryer

1 Answer

gas does not light then the flame sensor may have to be replaced. If the gas ignites but does not stay on either the flame sensor or the coils are at fault. See also: http://home.howstuffworks.com/how

Question about LGB6300 Gas Dryer

1 Answer

...flame is usually a result of impurities such as rust or carbon build up, so a good cleanting of the burner and thermocoupler is usually enough to correct the problem. At the worst replace the ...

Question about LGR8648 Gas Dryer

1 Answer

...filter is clean and exhaust is good. Could be a bad high limit thermostat. A bad flame sensor or bad gas valve coils. If you let it cool down and it re-lights correctly,replace the gas valve

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Dryers Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...