Questions & Answers for: coolant fan control 2004 jeep

...coolant to raise tank level to the FULL mark after each cool down period. For more details, you can refer to the Jeep WJ Service Manual Section-07-Cooling-System-Ewj7 Hope helped. 6Cyl?? 8cyl?? There ...

...still mis-behaves change the coolant sensor, check fan relay and connections. If water got into the fan motor, it may have caused a problem but the motor is supposed to be sealed and that's

...fan blows strong , Coolant temperature reading on dash is reading 190? what would a normal reading be ? Normal reading is around 195 degrees F. Probably needs heater control valve or backflushing of ...

...fan is controlled by ecu and temp sensor with relays ....the temp sensor should connect to a coolant passage on the intake manifold it is usually made of brass and sticks up with a plastic connection ...

...fan relay circuit. Code 35-Idle switch shorted-switch input shorted to ground-some 1993 vehicles. Code 37-Part Throttle Unlock (PTU) circuit for torque converter clutch-open or short detected in the ...

...fan on the radiator The coolant sensor is in the front the thermostat housing that the top radiator hose goes to has the sensor in it, but if your wandering cause your cooling fans do not work ...

...fan on high???????
does it fail in recirc mode and vent??
Does hot are work with car moving fast?
is engine at 180f or more>using tools to measure rad temp?
OR LEARN TO USE SCAN ...