Question about 46F500 46" Rear Projection HDTV-Ready Television
46f500 the tv picture has a wave across the top about half way...tried to magic focus in the menu screen but no luck any suggestions....thanks You most likely have a convergence chip bad. In our shop,
Question about 46F500 46" Rear Projection HDTV-Ready Television
...46f500 convergence? I have the 46F500 Hitachi Projection TV. The set has blue sagging down from the left side of screen and also has blue shadows. I removed the back cover to see if anything ...
Question about 46F500 46" Rear Projection HDTV-Ready Television
...46F500 and there is a blue curved bar There is a blue curved bar across the top half of the screen, there is also a yellowish line at the bottom of the screen. I have tried magic focus and it did no ...
Hitachi?s) This sounds like convergence output IC problem. convergence board would have to be removed - remove and replace 2 STK IC's and check the surrounding resistors. Shops usually charge between
Question about 46F500 46" Rear Projection HDTV-Ready Television
3d. I've went through all the menu setting and can't fix it Your son did not cause the problem. The convergence integrated circuit(s) have failed and requires an authorized Hitachi servicer to correct
Question about 46F500 46" Rear Projection HDTV-Ready Television
...46f500 46 in problem double picture end two collor This is symptom of convergence output chips failure in rear projection tv, replacement of convergence output chips will fix the problem. Chips/ IC ...
Question about 46F500 46" Rear Projection HDTV-Ready Television
...convergence problems,it dead.The tv colors lines R,G,B mis alignment,have colors shadows pictures or 3D pictures look alike.The tv convergence board have dead 2 STK convergence ICS and some or all of ...
Question about 46F500 46" Rear Projection HDTV-Ready Television
convergence problems,it dead.The tv colors lines R,G,B mis alignments,have colors shadows pictures or 3D pictures look alike?The tv convergence board have dead 2 STK convergence ICS and some or all of
...convergence problems,it dead.Tv have colors lines R,G,B mis alignments,have colors shadows pictures or 3D pictures look alike?The tv convergence board have dead 2 STK convergence ICS and some or all ...
...convergence problems,it dead.The tv convergence board have dead 2 STK convergence ICS and some or all of it resistors too on the convergence board,must replaced these parts to fix it.To solved tv ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions