Questions & Answers for: control knob replacement burner

...by a new knob. You have to be carefull since the replacement knob is a little different than the original part so you have to connect everything properly as per the provided instruction

control knob panel pull it away from grill and pull the burners out from inside the grill. DO the reverse to install new burners Remove the grates and burner heat deflectors. There are 4 screws on the

...control knob/burner Yesterday I noticed my center burner wasn't working. After a few minutes I saw a small flame under the center control knob. I turned the knob off, with some difficulty. Any idea ...

...and replacing burners, flame is wanting to kick back through air adjustment holes behind the control knobs. Ducane 5004 looking for electrail cord I don't think you "seated" the burners ...

...control knob to on position). I felt that the control knob is hard to turn, so I removed the control knob and cleaned the dirt underneath the knob. After that, the burner no longer leak. However, now ...

...onto the gas control knob correctly. Replace screws on the knob panel. ****Get a wire brush about the size of a tooth brush to clean the starter, the thing that makes the spark to start the

...control knob past the LITE position after the burner lights you should be OK and stop the clicking. If the clicking continues regardless you have a defective ignitor switch that must be replaced. ...

...control knob to ignite another burner. The other three burners ignite OK. The model is KM 93. There are three parts to the ignition system typically. The ignitor that is either in the burner or ...

...control knob may be stuck in the "IN" position. Turn the gas tank OFF, before attempting any repairs and disconnect the hose from the tank. Now that there is no pressure on the side burner control ...

...control knob be held in for 2 minutes or so, to allow the thermocouple on the infrared burner to heat up completely. If it's windy were you are, the wind can blow the burner out, while trying to ...