...point contacts then press the contact arm down lightly as you move the file in and out. Filing the points gives a new surface to pitted contacts. The standard gap is .015. I assume you have a timing ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...contact point of the magneto.,because what is more important is that what we called "timing".Be sure that the timing is :the sparkplug should be lit when the piston goes up to be closer into the ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...is the correct gap for a set of contact points and spark plugs for a 1300 cc 1972 vw beetle SPARK PLUG GAP IS 0.024 TO 0.028 AND CONTACT POINTS GAPS SETTING IS 0.016. DWELL ANGLE IS 44 - 50
...point set and slide your feeler guage between the contact pad and the lobe. Be sure the feeler guage is flat on the contact pad or your measurement will be off. Tighten the screw and slide the feeler ...
...point will move,one way to "open": the gap,the other to "close" the gap. With feeler gauge between the points contact,close untill you feel slight resistance when moving the gauge back and forth,and ...
...point gap. If the gap is too wide, bend the top contact arm down to correct gap and check timing again. If the gap is too small (less than.012"), the points need to be replaced. Good Luck, Steve - ...
overhanging a mark on the crankshaft pulley. The points were set to a gap suggested by the manufacturer. its the contact point that is used for adjusting the appropriate gap with the cam shaft in cars
Question about 1972 DT 360
...point of a knife. There should be a light drag on the feeler blades if, that is, they are set correctly. So, if the gap is 30 thousandths the blade or combination of blades should amount to 30 ...
...contact just as the 20- degree timing mark aligns with the flywheel timing mark. Final timing is corrected by properly shifting the breaker point box on its mounting and using a timing light. If ...
Question about 1972 DT 360
point gap relationship I have a mercruiser 140 hp I/o and am trying to set the points gap and spark plug gap Below are the Prestolite distributor settings. Point "gap" is merely the initial setting to
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions