connect it to a garden hose for drainage you first need the special connector pipe/adapter that comes with the unit. It's white plastic and about a foot long, It may be stored in the top of the bucket
...often difficult to trace. There are many possibilities to look for. The problem could be a loose connection, a broken hose, a cracked component, or a defective seal. It could also be a hole in the ...
Question about MAT13MN Top Load Washer
water seeping from hose connections in back. hoses are brand new. Seeping water from back of Maytag Hav2558aww make sure that the hose washers have been inserted properly and that the hose connection ...
...both water supply hoses momentarily 3. Set the water temp to warm 4. Remove ONE hose from the wall connection and place the hose in a the bucket. 5. Turn on the remaning connected hose/ 6. Start ...
Question about MTW5600TQ Top Load Washer
...ON COLD WATER TAP. CHECK FOR LEAKS. YOU MAY WISH TO CONNECT A HOSE TO THE HOT WATER TAP FOR FUTURE USE. I USE AN OLD SPARE WASHING MACHINE HOSE. I ALSO CUT A FEW INCHES OFF OF IT, FOR A SMOOTH
connect hose? which hose the drain hose or the two water hoses the drain hose connects in the back of your machine the two water filler hoses screw on to the two inlets on the water valve also in back
hose. Slow flow= plumbing problem Good flow = Connect hoses to washer Before you turn on the water check the wall connection end of the hoses. Sometimes there are hose screens there also. If there are
...connect hose to water valve and wall connection. Repeat procedure for the 2nd hose. This will clear about 50% of the water fill problems. If it does not cease the dripping while off routine you will ...
I connected a hose to my dehumidifier to drain the water. The water is still going in the dehumidifiers tank. What else do I need to do? Check the hose connection on the dehumidifier, as well as the ...
Question about Neptune MAH5500B Front Load Washer
washing. Could you please tell me what`is wrong with my washer. Water leakage 1. Inlet hose loosely connected to valve---tighten hose connection 2. Drain hoses not tight on pump----tighten hose clamps
Usually answered in minutes!
258 Questions
200 Questions