Questions & Answers for: connect to hose

Ad

Question about 1989 GSX 750 F (Katana)

3 Answers

...I have an 89 Katana and don't know where the two vacuum lines on the top of the carbs go I have the connection shematics. I'll try to explain, if needed send me your mail address, I'll send you a ...

Ad

Question about PAV2300 Top Load Washer

1 Answer

...often difficult to trace. There are many possibilities to look for. The problem could be a loose connection, a broken hose, a cracked component, or a defective seal. It could also be a hole in the ...

Ad

from the heater connection and connect that hose to the other hose connection at the engine. Take the free end just removed and connect it where the first hose connected at the heater. Hope this helps

Question about 2002 Escort

1 Answer

...overflow hose connect to? OVER FLOW HOSES YOU HAVE THREE HOSES THE 3/4 INCH HOSE CONNECTS TO TO RADIATOR TWO SMALL SURGE HOSES ONE CONNECT TO TOP OF RADIATOR THE SURGE HOSE GOES TO THERMOSTAT

...Connect the lower radiator hose to the water inlet connection. Fill the engine with coolant, start the engine and check for leaks. Stop the engine and top off the coolant recovery reservoir as ...

...Connect the upper radiator hose to the water hose connection. Fill the engine with coolant, start the engine and check for leaks. Stop the engine and top off the coolant recovery reservoir as ...

Question about LHD45EL Dehumidifier

2 Answers

...Connect a garden hose to the threaded drain hose connector. 3. Push hose connector tightly to the drain-hole on Rear Grille with the arrow on the tab pointing UP. The hose attachment will accept a ...

Question about DH304 Dehumidifier

1 Answer

...or attachments. Fortunately, it doesn't require a special hose, as a standard Garden Hose Connection is on the left side of the water collection bucket. You may have to carefully drill a

water leaks from underneath my washing machine. how do I fix it? the hose is connected properly, too Water leakage 1. Inlet hose loosely connected to valve---tighten hose connection 2. Drain hoses not

...connect it to besides the housing itself. I have found these hoses are firmly connected and require some force to remove. I figured since I only puled the hose in one direction I would see where it ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5922 Answers

Marvin
Marvin

Level 3 Expert

85111 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...