1992 chevrolet s-10 4 cyl. Idles fine until you give it some gas and it dies out.checked fuel pump woking fine what else could be wrong. Could be bad TPS sensor, bad MAP sensor, bad Oxygen sensor, bad
1992 s-10 stalls while driving, I just replaced the coil and the coil wire but no luck. check your relays. if a relay is failing they will usually get hot due to too much resistance and shut off, ...
1992 CHEVY S10 RAMDOMLY LOSES POWER My 92 Chevy S10 with a 4.3 liter loses power randomly. I checked the codes and found the map sensor, I replaced that but nothing changed. I noticed that during the ...
1992 Chevy S-10 Pickup 4.3L 6 Cyl. Engine sputters Engine sputters and knocks during acceleration. More pronounced after reaching operating temp. Had thermostat and on-board computer recently replaced
...1992 chevrolet S-10 V-6 begin with the #1 piston at top dead center on the compression stroke. Position your distributor and rotor to match up to the #1 plug wire. If you look under the glove box ...
...spark because the ignition-coil is getting hot or something is sending a trouble code to the computer, telling the computer to shut the motor off. Or you might even have a bad Fuel-Pump. It ...
...control module grounds to see if any of them are open, loose, or corroded. It may be that the computer is unable to ground the
1992 chevy s10 2.8l v6 tbi 2wd 5-speed. no signal on the noid light tried a new computer, new distributor, fuel pump and relay, fuses, can it be a sensor? or oil pressure switch? oxygen sensor? ...
Question about 1992 Lumina
...computer after you replace the sensor.You can do this by either disconnecting the ground cable on the battery for 30 seconds or pull the ECM fuse for 10 seconds orwith a code reader or a scan tool ...
where is the computer located? we are trying to locate the computer? remove inside of glove box and its up behind it under dash
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions