Question about 21.0 cu. ft. Top Freezer Refrigerator with IceMagic Plus Ice Maker
...is warm to touch, indicates faulty compressor. take all electrics off compressor and check for continuity thro windings. also check for power to compressor - if no power, indicates fault in ...
Question about 21.0 cu. ft. Top Freezer Refrigerator with IceMagic Plus Ice Maker
power is not getting to compressor, trace wiring and check .if power is getting to compressor the checjk start cap and relay . if they are good then compressor is bad , usually to expensive to replace
POWER GOING TO COMPRESSOR AND COMPRESSOR NOT COMING ON CHECK AC COMPRESSOR REFRIGERANT FOR LOW REFRIGERANT.LOW PRESSURE SIDE SHOULD BE 22 - 36 PSI HIGH PRESSURE SIDE SHOULD BE 200 - 260 PSI. NOW IF NO
...over works the compressor.best hope is just no power to compressor,so test for power and ground at compressor and if no power.power it up and raise veh or if there is power the compressor is
...power disconnected try turning compressor by hand if no movement possible seized unit There is a possible solution, you may try this soon. Article - ...
Question about 1995 Continental
...down. Check power to the compressor start relay. If power there suspect compressor fault if compressor hot. If compressor cold, suspect start relay. If no power to relay, suspect control ...
Question about 1995 Continental
...power to the compressor plug, and not sure where else to look, is their anything in the door or inside the freezer to check. Contact a professional. The power supply source needs to be testing to the ...
...power to and from thermostat and to compressor relay. If compressor powered but not running, compressor fault. If compressor running but no heat in condenser, short of gas. If compressor running and ...
Question about 1995 Continental
...tool. A 5 HP compressor needs plenty of power, a 30 amp 220 volt circuit, try finding a 5 HP 120 volts compressor. depending on power available, tools selection then a compressor size can be
...Power PCB and the compressor. This could include lizard or rodent damage If damage is found, replace damaged cable Check for correct DC voltage to the compressor is equal and correct If DC voltage is ...
Usually answered in minutes!
3,171 Questions
1,894 Questions
1,239 Questions
1,098 Questions
927 Questions