oil pressure falls from 4 to 2 bar while oil level when checked in cold condition found to be too high and oil diluted, smelling of diesel within. You run again the generator but before running, check
...loss of oil. Try this. Drain the sump completely, refill with the exact quantity of oil to Mazda spec. Dip the oil and if the new oil level is lower than the full mark on the dipstick, you have found ...
Question about GBW30P Encl Diesel Genset w/Perkins Eng
...pressure oil pump does not meet the requirements of the machine or the internal plunger of the high pressure oil pump is jammed. 4. There is air in the oil path. 5. The overhaul of the connecting rod ...
loss of oil pressure at idel on f250 turbo diesel The main bearing could be bad or you just need a new oil pump
...Oil Pressure & ETS) , alternator replaced, tension belt replaced. Both times that engine died restarted after after short time. Mechanic unable to replicate or find problem codes. Try or (have ...
...oil light stays on. I am at loss as what to do next You may have oil in the pan but that does not mean you have oil to the lifters, rods, etc. It sounds as if the oil pump has gone bad and not enough ...
Question about Swamps 200/30% Injectors Hot Street 94-97 7.3L Powerstroke
complete loss of engine power and knocking from injectore i had a knocking sound coming from the injectors , then last night on motorway , engine lost complete power and would not restart did you ...
Question about 2002 Bravada
...loss of power change the oil pressure sending unit on the eng. if this goes bad it sends the wrong voltage to the computer which will then detune the engine to reduce the chance of damage due to low ...
...oil pressure and loss some power very lower oil pressure and loss some power on the hill. engine be more loudy than before Low oil pressure starts from oil pump sounds like its blocked either in the ...
Question about 2010 308 HDi
...wire to the chassis, which simulates a loss of oil pressure (oil pressure warning light comes on). I don't think it prevents it starting, but it shouldn't run when you release the starter.
Usually answered in minutes!
627 Questions
549 Questions
535 Questions
166 Questions
208 Questions