...commander would not go faster than 25mph .It also would not shift into lower gears while in drive. It is an automatic transmission, v6, 4x4 with 17000miles. What is or was the problem? it would seem ...
Question about 2006 Commander
...Commander with 5.8l Hemi. Radio worked off and on, replaced. Check engine light on, replaced Oxygen sensor , came back on, reset computer and replaced something, Now the spedometer and tachometer ...
...Limp home " mode , this means that the computer has detected a fault and locked the trans in second in order to " limp home" . Our jeep did it because the injector seal was leaking ???? the computer ...
...limp mode-no power to solenoids.This is common symptom with this transmission, any failure big or small will put transmission into limp mode.You could have a bad speed sensor( your trans has 3)or ...
Question about 2007 Commander Rocky Mountain
...commander owned since 03/25/2013 69,000miles all of sudden wont turn on.the lights blink on and off and say Transmission over temp,check gauges ,check park system!I am so clueless to what could have ...
Question about 2007 Commander Rocky Mountain
...limp mode only allowing speeds of Vehicle has a mechanical issue. After 10-20 minutes of driving, the dash starts to light up and flash (check guages) before the vehciles goes into a limp mode only ...
Question about 2007 Commander Rocky Mountain
limp mode correct itself after known repaire needs are met or is a chip needed for reversal after repair, or just whats the process to recover from limp mode? I replaced transmission [$3000 in 2016 in
Question about 2007 Commander Rocky Mountain
...shift from 1st to 2nd gear. What could cause this? Any dash warning lights on? Usually when the computer commands a "limp in" mode it turns on a warning light and sets a trouble code int he
Question about 2008 Commander 3.7
...jeep commander goes into limp mode and throws no codes. v6 3.7 Get the service and repair manual from the given link this will help you to locate and fix the problem on your own
Question about 2008 Commander 3.7
...limp mode took to transmission shop was told transmission shift solenoid I replaced same issues don't know what to do need suggestions P0700,p1776,p0760,p1781 these are codes I’m getting Well, unless ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions