Questions & Answers for: combustion air gas dryers

Question about Nexxt WTMC 6500 Gas Dryer

1 Answer

...(winter )or outside ..is the hot air dangerous ie. carbon monoxide etc if it were electric I'd say it was ok, but for gas, the combustion products go out through the vent along with the

Ad

Question about Nexxt WTMC 6500 Gas Dryer

3 Answers

...combustion air for a gas dryer can you tell me where the combustion air is drawn from? I have a laundry room within a bedroom and was told by the fire inspector I could not draw the air from a living ...

Ad

Question about Nexxt WTMC 6500 Gas Dryer

1 Answer

...combustion air (and heat) is not drawn away from the burner, which causes the burner to short cycle. You may also have this same condition with the front on if you have a poor vent. Don't use any ...

Question about Nexxt WTMC 6500 Gas Dryer

2 Answers

gas dryer does not seem to heat up the air our dryer seems to use only cold air, and it takes hours to dry anything. any suggestions? Do the gas burners come on at all and is the pilot light on as ...

Question about Neptune MDG5500AW Gas Dryer

1 Answer

...combustion is smothering. Make sure the moisture vent and pipe are not restricted. Try running the dryer with the moisture vent disconnected and see if the problem continues and make sure air flow ...

Question about Neptune MDG5500AW Gas Dryer

1 Answer

...an orange/blue or orange, the gas is not being completely combusted, either the burner orfice tube needs cleaning or the air to gas ratio is off and needs more air intake and this can be adjusted ...

Question about Atlantis MDG6400AW Gas Dryer

1 Answer

...the dryer your burner needs cleaning and air adjustment,its not completely combusting the gas,watch flame and see if the flame is orangish/blue, then it needs clean, you want a blue flame all the ...

combustion, which would leave a residual odor while burning. Check your vent, on the outside where the flap opens and the exhaust leaves the building. Anything blocking that vent may cause an air flow

side of the gas combustion chamber. There is a pin in the center of it which needs to be pushed in to reset it. It trips when dryer has poor vent conditions. (long and / or restricted air flow in vent

Question about Neptune MDG9700A Gas Dryer

1 Answer

...combustion air supply (make sure inlet vents are clear), proper exhaust venting, flame sensor properly positioned and not cracked or otherwise broken, burner holes are clean and not caked over with ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Dryers Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...