Questions & Answers for: cold start sensor location 1997

...1997 Toyota Tacoma speedometer is making a horrible squeaking noise right in the dash. When it's cold the speedometer jumps around a little and makes a nasty noise. What should I try to replace or ...

...start when the engine is hot and sits a few minutes 1996 tacoma pickup 4 cylinder, 5 speed. when the engine gets warm and you stop somewhere for a few minutes the engine will not crank, just turns ...

...location, removal and instalation of a new starter on a 1997 toyota tacoma 2.4 with a manual trans. Pictures and instructions would be greatly appreciated. thank oh so very much! -Aren ...

...hard to start when the engine is hot. When cold the engine starts fine. 1. air filter dirty. 2. bad engine ground. 3. fuel filter 4. loose connection in ignition system. 5.faulty idle control

...LOCATION.YOU HAVE 2 # O2 SENSORS.YOU HAVE ONE THE EXHAUST MANIFOLD.THE OTHER SENSOR LOCATED DOWN AT THE CATALYTIC CONVERTER. YOU SHOULD ALSO REPLACE THE O2 SENSORS TO HAVE THE BEST READINGS FOR AIR ...

...1997 Toyota tacoma Hello there and thank you for choosing fixya Answer: 1-2-3-4-5- 6 3.4L V6. 1-2-3-4-5- 6. Valve Clearance. 2.4/2.7L(cold) ... Read more: ...

...sensor location check engine light p0500 On the early Tacoma, the speed sensor is located in the cluster and is driven by a cable attached to the transmission. Later models moved the sensor to the ...

...Position Sensor 1996 Toyota Truck Tacoma 2WD 2.4L EFI DOHC 4cyl The Camshaft Position Sensor is located: Under hood, passenger side, front engine area, below valve cover, mounted in ...

...sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products. ...

...air sensor and it may start easier. Check all vacuum hoses for splits/cracks and loose connections. Replace Throttle body gasket, check or replace cap, rotor and wires if not done in the last 2