Questions & Answers for: clutch wont disengage

...clutch wont disengage properly and i have already bled the clutch system with dot4 twice. anybody know whats going on? Bleed your slave cylinder on the sprocket cover and refill the hydraulic fluid. ...

...clutch wont disengage Hello, I have a 03 zx12r with 7000k i used the bike maybe twice last season of 08. I put bike away for winter, with running it at an idle through out the winter to keep fluids ...

Clutch wont disengage I have a 1991 Kawasaki Vulcan 1500 and the clutch will not disengage, stays in gear even when you pull in the clutch Wet clutches need the proper oil. Is there any possibility it

...wont disengage but shifts fine runs good ,can disengage it while rolling down hill or push start but not out of N i was told maybe nut came loose in the clutch housing Without power to the clutch and ...

...citroen c5 newly fitted clutch, wont disengage Check your pedal height, make sure it is set to specifications. It has to be a certain distance from the floor, if not it will not disengage the

clutch and it wont engage or disengage at all even with the car not running it wont go in gear It can't both not engage and not disengage? If you can't put it in gear even with the engine shut

...full size 1988 ford bronco its the 6 cylinder with the 5 speed took slave apart cleaned it,bled it an got all the air out an it wont disengage. Could be the clutch disk, or the clutch master

...wont stop. Whether I pull the clutch to disengage the blades or not is makes no difference. When I turn the mower off, I can hear the clicking each time I pull the clutch up and down to disengage and ...

clutch wont disengage worked fine last night then this morning clutch wont disengage try this https://www.youtube.com/watch?v=w0AmOBzYeHk https://www.youtube.com/watch?v=YO5VC7DcRkE

clutch wont disengage I just change it on a 1990 ser 1000 Yamaha loosen the clutch cable, until the clutch disengages