...petal. Later the clutch would not release, bled slave cylinder - no air. The petal will not release the clutch and travel down far enough to contact the starting switch. how is the best way to access ...
...getting off the highway i bushed in the clutch petal and it just stayed down on the floor, i powershifted it home but i cant seam to find why the petal wount spring back. clutch cable proberbly ...
Question about 1997 Civic
clutch petal is released but goes away when pushed in my 97 civic dx manual trans has a knocking when i release the clutch petal but gtal goes away when i push the petal in Does it drive fine. Does it
petal pressure or clutch 91 nissan pickup has on clutch pressure at the petal when it has a new master and slave what would cause this problem? Was the slave cylinder bled correctly? If that's all set
...clutch petal clear to the floor to shift, I bought it a year ago with only 55k on it. Very clean and i doubt clutch was ever touched. I did try new plastic bushing on clutch linkage. Helped some but ...
...seal is leaking through the fire wall where it is bolted to, when appling pressure to the clutch petal, it runs down the clutch rod that is connected to the petal, replace the clutch master
...clutch petal falls all the way to the floor and will not rise back up by itseslf. Tried bleeding it and petal remains the same. Are you sure the clutch disc and fork are connected to the slave ...
Question about 1985 S-15
clutch petal will not budge at all there is a squeaking coming from engine when i do manage to get the petal all the way in and then it wont go back in once i let off Clutch Plate Installed Backward ,
Question about 1998 S-10 Pickup
...clutch petal is very hard to push the petal is very hard and the clutch takes hold right at the top.what is the problem Most likely clutch is worn out, increases pedal height and pedal resistance, ...
Question about 1998 S-10 Pickup
Grinding noise when i let clutch petal out. But not when i press clutch petal in. Grind in all gears and in neutral Clutch plate worn out, sounds like it has past slipping.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions