clunking noise on Reverse shifts, you should be able reproduce this with the hood up and pinpoint the noise and/or sight the faulty motor mount with a friend's help. Good luck, I hope this puts you on
...Clunking Noise when shifting out of Park My 2004 Jeep Wrangler Sport, 48,000 miles, automatic transmission, normally shifts smoothly through all gears. Sometimes I get a loud clunk when I shift from ...
...clunking noise and when shifting in to drive or reverse it shifts hard. when driving shifts fine but when slowing down it doesnt shift down on time and when it does shift its real rough and jerky 1. ...
Question about 1995 Tacoma
...clunking noise. I think it is the differential. Can I fix this myself? I wiggled the u-joints and they are fine. I added gear fluid and the noise still happens. The noise happens in and out of gear. ...
Question about 1995 Riviera
noise. It does not do it if you shift into drive. After shifting to drive you can then shift to reverse with out the clunk. It's only after initially starting the car and shifting into reverse
Question about 2007 CTS 3.6L
...noise from my rear.. Is it the differential front carrier bushing? or is it the flex disc(s)?? please H E L P!! and Thanx!~ David I seen this before and is the upper rear axle support, or the engine ...
Question about 2007 CTS 3.6L
...drive forward a little it makes a noise that sounds like "ptunk". When I shift into reverse and start backing up a little it makes that "ptunk" noise again. Every time I shift between them it makes ...
...noise) when put into drive or reverse from neutral check ur cv axles one may be going bad also check steering and suspension system--struts worn, loose --ball joints goin --even tie rods can cause ...
...noise when takinf of and when you first go in reverse most of the time a clunk from under the vehicle when shifting gears (whether going forward or reverse) is a u-joint. check them at both ends of ...
Question about 2008 Pajero 3.2
I shift into Drive it clunks sometimes. Clunking noise. When shifting into Drive. And reverse. Not always. Took a vid of motor. Motor seems to jerk alot when put into gear. suspect drive shaft UJOINTS
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions