...light. Clip to frame or clip to one terminal and pointer to other terminal. If you hooked the clip to frame and the pointer to a terminal and it lit, it means that you have power there but not ...
...light and turn singles dont work but parking lights work,fuse is ok brake switch is ok and front turn singles work as well as hazerds for the front only work and singles bad turn signal switch broken ...
clip of the test light to the negative post on the battery(I know it is a side post),You may need a helper.Take the tip of the test light to the negative battery cable end.With the key out of ignition
...light 12 volt. It's an ice pick like tool with a clear handle and a ware with an alligater clip. hook the clip to ground near the ciol then with the key on the ciols small wires will be hot ( lights ...
...clip or adapter of the timing light to the # 1 spark plug wire, start vehicle, and loosen bolt at bottom of distributor, and turn the distibutor to where the white mark on the harmonic balancer will ...
...tracing to find the grounds and do either a resistance test with a multimeter, or you could also clip the ground wires and make new ground spots. Make sure its a good clean bare metal surface. ...
...light, ground the clip to a bare spot under the dash and shove the probe into the back of the turn connector (blue wire) at the base of the steering column. This connector is attached to the side of ...
how to remove front bumper? 2004 chevrolet aveo I have recently replaced the front bumper on my 2005 Aveo, after hitting a deer. The good thing to know, is directly connected to the bumper, there is ...
Usually answered in minutes!
363 Questions
210 Questions
125 Questions
