Questions & Answers for: clean rheem tankless water heater

Question about Tankless Water Heater Manifold Control Box

2 Answers

...Rheem) This is a tank sys.Ignor posted part no. most likely a flame sensor problem.remove fl sensor , clean with steel wool or fine emery cloth,replace and it should solve yor problem it will cost to ...

Ad

Question about Paloma Tankless Water Heaters PTG-74PVN Tankless RTG-74PVN

1 Answer

clean. I have the same problem since i bought this stupid water heater, it sucks. I had there service men come out and all they did was clean the burner sensor. Few months later i had the same problem

Ad

Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm

1 Answer

...Rheem) tankless water heater 7.4 gpm 199,000 btu outdoor unit. Red light is blinking on pc board. unit fires up for approx 2 seconds then shuts off, then cycles once more for 2 seconds and shuts off. ...

Question about Paloma Tankless Water Heaters PTG-74PVN Tankless RTG-74PVN

1 Answer

...water heater. Clean the unit to establish adequate water flow. Remove all faucet aerators and turn the faucets on to activate the unit. If you still get the on and off problem you need to call the ...

Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm

2 Answers

Rheem-Tankless-water-heater.html Error codes are considered start place for troubleshooting. C2 11 is 'No ignition' or 'Gas is inadequate' or 'Ignition failure' Error C implies

Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm

1 Answer

...Rheem-Tankless-water-heater.html Error codes are considered start-point for troubleshooting. Error code 12 is Flame failure. Try cleaning the combustion parts, and replacing flame rod? Problem can be ...

Question about RTE 27 Tankless Electric Water Heater

1 Answer

rheem 27 ignites for about a second when cold tap turned on When you ignites, I assume you mean it fires. If so you have a dirty or defective flame sensor. Usually they can be cleaned with steel wool ...

Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm

2 Answers

...water tank stay lit there is no pilot- it is lit with a ignitor. If you have problems the unit needs a service cleaning of the flame sensor rods. A number of things. 1 st start by changing the flame ...

Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm

2 Answers

...clean it more thoroughly on the bench, maybe even replace the heat exchanger. So far it's working great. note: Anyone with the ability to responsibly turn the gas off, a long Philips X-head ...

Rheem RTG-74PVP tankless hot water heater. A red light blinks 4 times. What does that indicate is wrong? Two things- Clean the sensor rods or replace(cheap and easy with YouTube instruction video) and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

David Spradling
David Spradling

Level 3 Expert

13524 Answers

Are you a Pool & Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...