Raypak heater won't stay ignited Just tried turning on the RP2100 for the first time. The spark seems to ignite and start heater. It then turnes off and shortly thereafter reignites again, then turns ...
Question about Free Hydraulic Lift Gate Delivery - No L...
...Raypak pool heater the pilot will lite but the unit will not ignite. I have good pressure checked filters all clean. . My Rapak gas pool heater burner will not ignite. I changed the flame sensor and ...
Question about Versa 130,000 Btu Above Ground Natural Gas Heater
...pool heater everything seems to work fine. The display comes on, shows the set point and then says "spk" (spark). I can hear a buzzing (im assuming the igniter) and after a few seconds the main flame ...
...clean and free of debris, and the gas supply is turned on and correct, you simply need to purchase and install a new ignitor for this heater. I would normally list the part number and a place to buy ...
Question about Versa 130,000 Btu Above Ground Natural Gas Heater
Raypak versa heater Bronze series, warms up to approx 90 degrees, but then before reaches appropriate temp, it seems that it stops heating hear flame turn off, and then it starts back up again. Heater
Question about RP2100 DIGITAL POOL HEATER R265
Raypak 2100 heater: I turn on the heater and the following sequence occurrs. spk on the display and igniter sparks, cfh comes up next on the display and the heater fires. It stays on for about 20 ...
Question about Digital ASME 337A 332,500 BTU for NG Low NOx
...Raypak 337A heater won't ignite. Gas is on. Heater hasn't been turned on in 6 months. I hear ignitor sparking. SPK digital reading on. After 1 minute, I turn off. try a couple more times flame sensor ...
Question about 406A Digital ASME Natural Gas IID Heater009271
raypak pool heater model 406A fault code rollut sw open not working rollout sw open message displayed you had a flame roll out. thermal fuse is blown. you can buy one for about 10 bucks. then you need
Question about 406A Digital ASME Natural Gas IID Heater009271
Raypak 2100 heater: I turn on the heater, igniter sparks, the heather fires an about 20 seconds later the flame goes out dirty or bad flame sensor or burn tube below sensor not burning make sure clean
Question about 406A Digital ASME Natural Gas IID Heater009271
Clean the flame sensor using a soft cloth or a non-abrasive brush. 4. Verify Proper Ventilation: Ensure that the heater's venting system is clear of any blockages. Blocked vents can lead to incomplete
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions