...HT5E Steam Series Washer with an F20 erroe code.. can't find the users manual... can you advise what this indicates and a fix?? no water in unit,,,check inlet hose,,or clean inlet ...
...inlet valve screen and it was clean. What is my next step to do? Thx Hi, If there is good pressure to the valve and the screens inside the valve are clean, you will need to replace the inlet valve. ...
...clean out on this washer? If so, how do I aceess? If no, what could the problem be? There may be a screen in the inlet pipe where it joins the back of the machine. Also check that the inlet pipe is ...
Question about 24032\24036 Top Load Washer
Kenmore 80 series washer with setting on cold/cold the water doesn't run You might want to try cleaning the cold water inlet screen. Turn the water off where the hose connects to the faucet. ...
...Kenmore 400 series is taking too long to dry My Kenmore 400 Dryer series is taking too long to dry clothes. there is some heat, but maybe not hot enough. Make sure the vent and tube are clear and not ...
Question about 22422 Top Load Washer
...at the faucet ends. The screens are usually replaceable if you can't get them clean in a white vinegar/hot water solution. Check the inlet ports to the washer for similar screens. Hope this
...inlet valves and for continuity and i do think thats the problem I TO THINK YOU HAVE A PROBLEM WITH THE DOOR SWITCH. BUT DID YOU CHECK THE WATERINLET LINES WHERE THE HOSES HOOK UP TO THE WASHER? THEY ...
Question about 24032\24036 Top Load Washer
...Kenmore 400 series washer does not seem to be releasing the fabric softener properly. It ends up all around the top if the barrel and spotted on my clothes as well. Anything I can do other than go to ...
Question about 24032\24036 Top Load Washer
...clean inlet water screens? Remove the hoses and check both ends for clogs. Shut water off first. Check inlets on washer as well. On the back of the unit are two hoses. Shut off the water supply to ...
Question about 24032\24036 Top Load Washer
...on display. Book says water inlet screens. I cleaned them up. Now does the computer need reset? Not an expert, but I'd unplug (or reset the breaker) leave it off for a minute and then plug it back
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions