...fan to turn on. The green light is on inside, the fuse seems fine, the filter is pretty clean, the plate is clean. I replaced the connector on broken red wire that was connected to the post labeled ...
Question about Living Air Classic Air Purifier
Fan on Living Air Classic Electronic Air Purifier Broke a blade on fan while cleaning, need to know where I can get replacement fan and at what cost? Try this link http://www.alpineairproducts.com/#
...plates and fans are both good. Thanks Mine has a switch lower right hand side that will stop the ozone. HI,I HAVE A LIVING AIR XL-15 S,SERVICE REQUIRED LIGHT IS ON,UNIT IS CLEAN ,BUT NO ...
Question about Living Air Classic Air Purifier
...fan, BUT ..... there is no clean smell coming from it - everything appears works .. but i can not smell the ION Clean Air ? look through the front grill while its "on" you should see a glow from a ...
Question about Breeze AT Living Air Purifier
...lubricate the fan. How do I get to it? Email to [email protected] and ask for free supplemental cleaning instructions. The cleaning instructions include detailed fan removal instructions. The ...
Question about Breeze AT Living Air Purifier
Living Air does not create any ozone. The fan runs but the green light only turned on once. Are the plates cleaned? They should be cleaned once a month by soaking in 1 part amonia and 1 part water for
...a while then shuts down, fan would not re-start every cycle, causing over heating and shut down, cleaned the fan, oiled the bearings, cleaned all the elec. connections, seems to work
Question about Icer-ette Ice Cube Maker
HELP!!! Hmmm sounds like you should ditch the fans as you live in dirty area and git yerself an air conditioner. I use this kind as a window fan and it’s great and easy to clean. Very inexpensive too
...clean living tower fan? Usually there would be a few screws in the base that need to be taken out and the outer case pulls out. This will expose the fan and filters inside. Hopefully that will allow ...
...fan is fine and the power feed to it is at fault. It could be a broken wire, bad grounding or more likely the temperature sender. To locate, follow the original live wire and it should be fitted to ...
Usually answered in minutes!
271 Questions
141 Questions
164 Questions
134 Questions