Question about HLN5065W 50" Rear Projection HDTV-Ready Television
...DMD board is where the chip resides but if you order a board, it will come without the chip. Its not cheap and the replacement is tricky because the DMD board must be removed and then an alignment of ...
...clean the lamp and outside part of the lens but doesn't change anything. Tried blowing the whole unit with a blower but none of them came off. Not sure if it is a fungus in the inner part of ...
...clean for your projector DMD chips or color weel, if it still ahs whie spots, It should be dead pixels, since for the DMD chips issue. you have to replace a new DMD chips. i have DMD chips fit for ...
Question about X1261 DLP PROJ SXGA 37001 Multimedia Projector Projector
clean up with KF special contact F2, chip pins, socket, cards connectors, but nothing worked, still vertical white lines with 1079-6329W chip ( instead of 1079-6319W). I hope this can help everyone in
...DMD CHIP 8060-6319W for a LG DS420 DLP Projector cheaper than 200 dollars (150 euros)???? May not be the chip. Look for a haze build up on the optics that the lamp housing contain. The color wheel ...
clean light engine dark spots in image appears to be dirt inside the light engine 1,white spots appeared on screen,means the DMD chip is broken,you need a new DMD chip.I supply the DMD chip and the ...
...clean the dmd chip itself. Very carefully. Here is a video of a similar unit. SO far all the DMD projectors I have worked on have had a very similar set up. Take pictures as you go. MItsubishi XD206u ...
Question about PJD5132 SVGA 800x600 DLP Projector
My 55 inch Mitsubishi hd 1080 has white spots on screen it is dmd chip issue. dirty or goes bad. firstly, try to clean DMD chip, if no helpful, you have to replace it by a new one. good luck for you
Question about PJD5132 SVGA 800x600 DLP Projector
DMD chip? Or just a cleaning problem? I did run the unit with a pixel flash software, but nothing to do ... Help me please! Yes, unfortunately the DMD chip has gone bad and will require to be replaced
Question about K11 Projector
...DMD chip is failing, the only fix is to replace the chip. Also if you do replace the chip make sure you use decent thermal paste between the chip and heat sink, and clean all the dust out, especially ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions