Questions & Answers for: clean contactor

...connections for loose or coroded, then clean them (file or sand them or just add oil to the ends connectors and go with a higher 24-va contactor instead of a 40-va, maybe a 80va 24-volt

...contactor coil problems? Jumpered the bimetal thermostat and everything worked smoothly. Tried to clean contacts in thermostat with no luck, so ordered a replacement. At least it was cheaper than the ...

the outside unit won't shut off, even when the blower is not going. I flipped off the breaker and cleaned the coils. When I turned the breaker back on, the unit came on, even though I turned off the ...

...contactor stays closed, replace the contactor. Even if you clean the contacts it will stick again. If the contactor opens replace the wire and check the thermostat to see if it is operating

...times in our part of the country, there will be ants stuck in the points of the contactor. Just cleaning the contactor will buy more time. Hope this

Shut unit down for cleaning, outside unit will not start now, I have line voltage at the contactor but the contactor will not engage.one wire from the thermostat runs to a little black box next to the

I have SYNAIRG4 ....digital readout said 'perform cleaning'....I did....to out filters washed and replied, put in new ceramic plate...restarted it.....digital read out...'perform cleaning'.....what ...

...contactor. No supply (line voltage), then check breaker Breaker on, then check run capacitor and if good check high and low pressure protection.High pressure = trips on high head pressure (manual ...

...contactor,make sure the connections are all clean on the control input terminals at the contactor.(The contactor is the device that changes the polarity of 12V to the winch to extend or ...

...clean the contacts on the contactor (if exposed type) also if they are open air type, make sure no small furry friends have tryed to make a home in there, My AC contactor had a small mouse ends it ...