...circular saw manufacturer, Skill. These are the backbone of the construction industry, used for cutting lumber up to 2 1/4 inch thick. They are used for cutting framing lumber to length, and ripping ...
Question about Craftsman 7-1/4 in. Circular Saw with LaserTrac and 5 Bonus Blades
4HP Tecumseh flat-head head-bolt torque? I have an older Sears CANADA Craftsman ''Eager 1'' walk-behind (rr wheels driven) lawnmower w/TECUMSEH 4 HP vertical-shaft 4-cycle, Flat-head engine. Not found
Question about Craftsman 7-1/4 in. Circular Saw with LaserTrac and 5 Bonus Blades
7 1/4 B&D saw - blade stalls but motor continues to run When the saw is put under a moderate to heavy load it will cut a few inches and then the blade stops but the motor continues to run without ...
Question about Craftsman 7-1/4 in. Circular Saw with LaserTrac and 5 Bonus Blades
...inch blades, can I find that in a store or do I have to order it?? You will find a large selection in any decent hardware store. You can also use 7" blades in your saw. the important thing is dont go ...
Question about Craftsman 7-1/4 in. Circular Saw with LaserTrac and 5 Bonus Blades
...5 1/2 inch trim saw quit running after cutting a bunch of 2x4s Does it have any sort of blade safety lock? Did the blade bind and possibly throw the built in circuit breaker? If so, there may be a ...
Question about Professional Grade 7.25 Inch Circular Saw
...saw will cut for 5 seconds and then the blade stops spinning. When I back the blade out it starts again and the process is repeated. It takes a long time to cut wood this way. What's the problem? ...
Question about Craftsman 7-1/4 in. Circular Saw with LaserTrac and 5 Bonus Blades
Circular Saw. How to true it so I can again set correct depths? With the saw unplugged, lay it upside down on a bench or table. Put a small scrap of 2x4 against the blade and adjust until the depth of
Question about BCS550 18V Lxt Lithium Ion 5 3/8 Inch Metal Cutting Saw Kit
...circular saw but now it is going in reverse, any help greatly appriciated. I believe the motor is a brush style unit (only an educated guess) I would revers the wire going to the armature. Most small ...
...the hole is 5/8 inch. Just take your saw with you to the store and try a blade on it. If the hole is a nice fit, your are good! (You posted this under circular saws, so I assume your saw is
Usually answered in minutes!
386 Questions
103 Questions
81 Questions
63 Questions