Question about 04' and Up Chrysler Sentry Immobilizer Interface for Remote Start (556CW)
Chrysler Sebring ECU replacment - Mitsubishi Computer I replaced the ecu in my 2001 chrysler sebring 3.0L and it is a misubishi ecu. When I installed it the car will not start. I beleive it is a ...
...sebring 2001 have a chip in the key? does it have a chip in the key the ignition key contains a transmitter that is read by the ignition key ring antenna, the antenna sends registration code signals ...
...Chrysler Sebring P0442 455 and 1685 What do those codes mean. PO442 means you have a small leak in your EVAP system. Most common cause is a bad gas cap, replace the gas cap with a factory gas ...
does chrysler sebring 07 model need bypass module do i need to buy an immobiler bypass to install a remote starter for my 07 sebring touring? yes you will need a bypass,
...chrysler sebring with a 2.5 the problem is it starts some time and then shuts off it will start a couple more times and do the same thing and then it wont do nothing at all Does your car have the ...
...System for the 2008 chrysler sebring??? What do you mean by reset? If there is a fault, you will need to diagnose what is causing it. Is the red dot light staying on solid or blinking? SOS ...
...Chrysler Sebring wont start We replaced the ECM the alternator and the crankshaft sensor. Now it won't start. Sometimes I can get it started it I lock it with the key, wait a few minutes and ...
Question about 2003 Sebring
chrysler sebring wont start a little red dot blinks when try starting it when I try to star my 2009 Chrysler sebring it wont start and a little red dot starts blinking The red dot indicates a fault in
Question about 1997 Sebring
On my 1997 cryseler cybring two door convertible 2.5 v6 engine cranks but won't fire check for broken timing belt/chain check cam /crank position sensor operation check for fob key operation/ ...
Question about 1997 Sebring
...Chrysler Sebring just died one day while driving won't start????!! reasons include broken timing belt/chain immobilizer crank/can position sensor failure lack of fuel pressure Ignition comtrol module ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions