...setting the fast idle? You should be. Better? If your start procedure is similar to below and your fuel hoses have no cracks or holes the carburetor needs adjusting. A tune up might be a good idea. ...
CHOKE Start Procedure Cold: Ignition on/off to on Set compression release ? optional step even if saw is equipped with a compression releasePull (close) choke, set fast idle (done when choke closed on
...start procedure in your manual. Don't use choke on flooded engine (may set fast idle, set then turn off)! Extreme Flooding by Dolfoff Please follow this link, ...
...choke closed on some saws); pull starter and listen for an attempt to start. once heard (usually two pulls; no more than 4)Set compression release ? optional step even if saw is equipped with a ...
...choke closed on some saws); pull starter and listen for an attempt to start. once heard (usually two pulls; no more than 4)Set compression release ? optional step even if saw is equipped with a ...
...choke, pull rope. Start Procedure Cold: Ignition on/off to on Set compression release ? optional step even if saw is equipped with a compression release Pull (close) choke, set fast idle (done when ...
start. Try it without 1/2 choke (your manual); completely open. Start Procedure Cold: Ignition on/off to on. Set compression release ? optional step even if saw is equipped with a compression release.
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
choke off 6) Pull over engine. If it does not start you may have flooded engine ect. Please let me know. Start Procedure Cold: Ignition on/off to on Set compression release ? optional step even if saw
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...start procedure is the fault, the manual is not correct IMO. Any choke on a warm engine causes flooding, try this, if no better post back or return it for warranty replacement. Start Procedure Cold: ...
start running. Half choke should release as soon as you hit the trigger. Start Procedure Cold: Ignition on/off to on. Set compression release ? optional step even if saw is equipped with a compression
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions