...FXDL and noticed a vibration starting about 2500 RPM, peaking at 2900 and then dissipating by about 3500 rpm. Bike was new in April and had 4500 miles on it when she dropped it mid November. A few ...
...motor mounts and compression test and all is good. looks to me like the front mount moves about 1/4 inch Any input would be great!!! Bring it over let me ride her for a few years and I'll fixit for a ...
...mounts and starting motor (as per manual) The easiest way to check rear wheel alignment on a Dyna is by the two little "witness marks" on the rear swing arm. These two marks are just forward of the ...
mounts . Have you checked the front motor mount to make sure it is not worn out. If you put a small scissors jack under the engine, you can take the front motor mount off. The noise may be coming from
motor-mounts though, problems there, loose out of alignment etc could be the problem. If the front end shakes it could be wobble, check tire condition, age and cupping, balance and wheel straightness,
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions