Questions & Answers for: check upper lower thread cut

Ad

Question about Bernette Deco 600

2 Answers

...Check upper or lower threads may be cut . I have looked it all over and what it is looking like to me is that the upper thread is not catching the bobbin thread. I have tried changing the bobbin the ...

Ad

Question about Bernette Deco 600

2 Answers

...upon how much it is pulling the thread under. A perfect tension on embroidery is about 2/3's lower thread and 1/3 upper thread showing on the bottom. sewman7 my bobbin thread shows on top ...

Ad

upper and lower over a dozen times it still will not pick up the bobbin thread. I have taken off the plate and there is nothing jammed in the bottom of the machine, bobbin is new. Thanks! Try changing

...Check if upper or lower thread is cut shows on The message check if upper or lower thread is cut shows on machine. I replaced the needle and re-threaded the machine. I also re-winded a new bobbin and ...

Question about Bernette Deco 600

1 Answer

...says The upper and lower thread is cut. Is this something I can adjust myself. Thank You Maureen Maureen, I had the same problem and had to take it in for repair. The timing was off. Cost was ...

Question about Bernette 75

1 Answer

...thread. I need to know the correct placement of the cutting knives. First to see if the top blade is pressing against the lower blade when it goes past to make the cut. You should be able to push the ...

Question about Bernette 75

1 Answer

...lower the tension down on the upper looper so this thread goes over the edge to the underside and tighten up the lower looper dial so this thread lies against the needle stitch. Move the blade to the ...

Question about Eclipse Serger

1 Answer

...upper and lower looper tensions until you get the lower looper thread almost not showing, it should be right up against the needle on the underside with the upper looper thread completely wrapping ...

Question about Eclipse Serger

1 Answer

...Upper Looper, Lower Looper, then needle(s)Open the front panel to get to your lower loopers and I think there should be a threading diagram inside on the door.  Then always have test fabric that ...

tighten the upper tension. If the top thread is appearing on the underside of the fabric, it is too loose and you need to tighten the upper tension. (Lower the number loosens, higher number tightens.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Sewing Machines Experts

Tally Girl
Tally Girl

Level 3 Expert

1134 Answers

Chris Wetmore

Level 2 Expert

187 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

Are you a Sewing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...