Questions & Answers for: check suction dyson dc14

...suction...see if this works...turn the Dyson upside down...there is a length of hose that connects the bottom of the vacuum to the top, careful remove one end of the hose and check for debris...mine ...

...suction has not improved. Please help. Thanks Two possible solutions come to mind. First off, there is a clog in your hose. If you have another vacuum, try using the hose on that one to **** it out. ...

suction to pick up dirt. What should I do? Check for an obstruction. There are several cleanout ports built in to make this easier. Also, check filters. Worst case, consult this article for help: http

...check this, remove the wand/hose from the machine as if you were going to use it to vacuum the stairs. Switch the machine on and test the suction at the top of the wand handle with your hand. If the ...

...Dyson. A loss of suction is most likely caused by a blockage or a dirty filter. If you have cleaned the filter, it would be worth checking the machine through for a blockage by following the user ...

...suction in the reclined position. Works fine upright with the wand. Any idea what the problem is? Thanks Check the brush bar is turned on, read this article: DC14 clutch and brushbar Then check the ...

...Dyson DC14 previously had suction through the bottom, but not through the wand. Now, it has no suction through either, the brushroll is not turning, and within a few seconds of turning it on,it ...

...Dyson work at base with brushes I have removed and checked for all the areas to clean, but it won't suction at the base where the brushes are..I have cleaned the whole unit, followed directions. ...

dyson left slightly, bad suction going forward, strong suction backwards Check and clean all filters. Check drive belt too.

When i turn it on it sounds like there is good suction then there is a second noise like the suction is escaping somewhere. check this video out You-Tube video "l1SvGJAjukY" placeholder (do not delete