Questions & Answers for: check rear end noise 01

...plug wires on aztek 2001 how to put spark plug wires back together in order on my Aztek 01' ? cause i v'gotem all messed up Check here: ...

...Check your exhaust make sure a hanger hasn't come loose the pipe might be tight a the back but there might be a loose hangar they just sit in that rubber mount and can easily come out with some wear ...

...fluid is about $40 per bottle and you need 3 bottles. Thumping noise is from loose rear knuckle bushings. These are part of the entire rear knuckle assy. and you must replace complete

...check your shock absorbers get the rear tires off the ground if you give the tire a spin and it spins and spins you dont have rear drum drag . if you spin the tire and it goes less than half way ...

drive. this sounds like a rear end or u joint issues. Get under the truck and grab the drive line, if you are able to turn it more then a 1/4 inch each way bad u joints. If not then check the rear end

...rear end fluids being low. i would put money on tht being cv axel shafts Your car should be a front wheel drive which means no rear differential. Try jacking up the rear of you car (if capable) and ...

...check the upper shock mounts on the rear. These go bad and will cause noise as well. About $15.00/ea. Easy to replace. The skip sideways is because the link assy or rear alignment is off. This is ...

...noise in the rear only when braking. I see comments about the knuckle bushings needing to be replaced though this is a Front Wheel drive Aztek (not AWD) and I dont believe there are knuckle bushings ...

...end scan tool. You can't do it by disconnecting the battery overnight, but that can cause all sort of new problems. Where you say your speedometer 'sets' at 55mph, do you mean always stays at 55 even ...

...01 pontiac aztek? I need to replace the rear driveshaft on my aztek as the rubber boot on the driveshaft going into the transfer case has disintegrated. I can't find a scrap aztek anywhere, but I've ...