...Check Engine Light on? It should briefly light up when you turn the key on (before you start the engine) to show that the light is working correctly. Based on what I've read I believe you should have ...
check engine light my 1999 dodge 2500 cummins has a TPS pedal position sensor A code causing check engine light to come on is this something that needs immediate attention and what is it thank you ...
check engine light on / limp mode - what to do? It may have a "loss of prime" code that usually follows a service of the fluid and filter. After you're sure the fluid is full at operating temperature,
Question about 2007 Caliber SXT Sport Hatchback
check engine light went on. car went into limp mode. dealer only to clear the limp mode
Question about 2007 Caliber SXT Sport Hatchback
...check engine light 1990 dodge dakoda 3.9 L the engine over heated, Bad water pump, I replaced the water pump now the truck is in limp in mode it has no trouble codes and the check engine light does ...
Question about 2003 Stratus
...check engine light came on then trans went int limp mode. po700 and po888 came up on my scanner. I knew my battery needed to be replaced and also thought that pcm was reading low voltage and thought ...
...mode The van has no fault codes, the check engine light is Not on, and it is stuck in limp mode. check your tcm connectors ,tcm is in your drivers side wheel well possibly bad connection or broken ...
...CHECK ENGINE light... (?) My best advice is to limp on down to your near-by FREE code reading shop... and have a READER tell you what CODES are registered... A blocked exhaust system will also ...
Question about 1998 Durango
engine soon light is on ? Did you have it checked for DTC'S - diagnostic trouble codes ? Check your codes....its in limp mode. have codes read most auto stores offer service for free --your vehicle is
Question about 1998 Durango
check engine light on. 1004 means you had a disconnection or flat battery. 0016 crankshaft position sensor has no/poor signals. 0404 check the EGR sensor. Probably a bad connection in the engine loom.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions