...check or replace your separator plate as sometimes the check balls that regulate the hydraulics of the transmission become stuck onto the plate. I've done quite a few of this model transmission and ...
...separator plate was worn where the balls sit. the 2-3 control solenoid had high resistance. I'm sorry to say this, but with my experience, it doesn't look good if its leaking really badly. I rebuilt ...
...check ball stuck in the separator plate i just assumed it was stuck from trash or something. Now that i am having trouble i have been doing research on problems related to this and found that one ...
...4L60e automatic transmission, you will have my undying appreciation. Sincerely, Thomas You will also need instruction of the ball bearings mounting areas in the valve body too. Good luck in your ...
...is known to have check ball problems. If you have a 700R4 (has a cable to the carb to shift) Its just about the same inside as far as the clutches. There are repair books on e-bay to help. Good
...check balls getting stuck in the spacer plate in the valve body assembly.These components are internal. the spacer plate and gaskets are around 60 dollars and a valve body,if needed, is around 275 ...
...There is also a check ball that goes in the case next to the 2-4 accumulator. google it if you are not
keeps blowing the o'ring in the transmission valve body Could be a check ball has stuck in the VB separator plate. Year make model and transmission helps.
Question about 1997 K1500
separator plate with it. You also need to swap the internal harness. Be careful because there are 8 check balls in there. One at the case and seven at the valve body. They have to go back in the right
Question about 1997 K1500
...STICKING CLUTCH PACKS. EPC bad or its filter clogged. electronic pressure control LOTS MORE AS LOTS THERE, even bad pump.or bad TC https://www.transmissiondigest.com/4l60e-harsh-1-2-shift/ wild guess ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions