Questions & Answers for: change wet end waterway spa

...WET END OF WATERWAY PF401A22C-LEAKS- NEED DIAGRAM I RE-ASSEMBLED THE WET END OF A WATERWAY FRAME 56 PUMP(PF401A22C) NOW IT LEAKS I NEED TO SEE A REASSEMBLY DIAGRAM IF YOU CAN HELP. I've never seen a ...

...change the wet ends slightly (the difference is only minute and you wouldn't realise without meausring) and if yours is the older version you may need to change the entire wet end. I'd advise you to ...

...wet end. i came with the seal installed i ordered a new slider mine broke. without the slider the wet end leaks at the motor shaft. will the slider stop the leak? Should there be an additional rubber ...

...wet end out, and managed to turn the shaft to free it. It has rusted up in place. 6 months later it started the loud noise and started getting worse - the motor bearing at the wet end was seizing up. ...

Waterway pool pump wet end PN LB31511708 just replace whole pump better off

I have a 2hp side discharge waterway pump,how do I rotate the wet end of the pump take the screws out of housing and rotate without pulling out

there is water leaking from my 5 hp waterway spa pump and it blew the breaker there seems to be water leaking on the wet end need new pump if leaking bearings next replace whole pump

...wet end, or pump. Use a 1/4" nut driver and loosen the bolts until they are free of the wet end, then you can rotate the wet end so the discharge is face to the side. Tighten the bolts and your

...wet end on waterway 4 hp split wet end from motor take off cover to impeller unscrew impeller screw should be backwards thread hold back of motor with wrench after screw is out turn the impeller off ...

...wet end assembled to a 56 frame, 5hp, 2-speed 230V spa motor This Spa pump has a 2-1/2 inch intake and a 2 inch discharge for plumbing (but measures 3-1/2 inch and 3 inch- see bottom of this ...