...washer stopped in middle of washing cycle. Tried to change cycles and wil not respond. I hear a buzz like it wants to but nothing happens. How can i drain water? What may be the problem with washer? ...
Question about GLTF2940E Gallery 3.5 Cu. Ft. King Size Front Loading Washer
...change. Only soppy wet soapy clothes. Please give the make and the model # the problem is the door.The door does lock, but does not send the correct signal allowing the washer to spin!! Sergio The ...
CHANGE CYLE ETC. CYLE TIME IS INDICATED, DISPLAYES do when "DOOR OPEN". UNPLUGGED TO RESET, DID NOT WORK. If your washer doesn't seem to work at all, check these: No power Lid switch No power Check to
washer will not change cycles The washer washes but will not move on to rinse and spin stages. If the washer fills and doesn't do anything, or stops right after the wash cycle and then does not ...
...washer to replace the lid switch Check the video at the following link and see if it is of assistance to you in changing out the lid switch. Sure hope so and best wishes. ...
...washer model 100.24942301 is having an issue with the lid switch. We close the lid and the machine doesn't start. IF we lift the lid and drop it, it starts washing. It appears the switch is making ...
Question about Ultimate Care II LSQ9564J Top Load Washer
change how to take washer apart at top Remove screws from rear of timer console, pull console forward and hinge it up to expose brass colored clips. Remove these clips and unplug lid switch connector.
Question about Ultimate Care II LSQ9564J Top Load Washer
change at all, then the lid switch is faulty. Replace it and the washer will now spin. If the lid switch is OK, go on to the next step.Washers pump out all the water first, and then start spinning. If
...lid lock switch and won't work Thought it was the lid lock switch and it fills up but won't wash so we changed the lid lock switch Is the plunger attached to the lid? It is the little prong that goes ...
washer it will not change from wash to spin If this is a top loading washer it is likely the lid switch. If the tab has broken on the lid the switch will not actuate. The switch can be replaced by an ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions