...with a belt tensioner that keeps the correct tension on the belt. check the belt and all the pulleys for wear. if the belt and pulley are in good shape i would suggest changing the belt
set of hands may help,then with one guy holding back the tensioner you should be able to slide it onto the alternator pulley[if it's routed correctly,check the diagram under the hood for belt routing]
...replace my alternator on my 1996 chevy corsica? I know where the tensioner is, but can figure out how to relieve tension on the belt. its on the alternator undo the bolts and the belt will come ...
...chevy. corsica and need to adjust the tension Apply tension to the belt until it is snug and has a live spring action when stuck with the hand dead center. For a more accurate deflection measure the ...
...with a pulley wheel...you can use the socket end of your 3/8 drive socket wrench to release the belt tension, and remove the belt...the slot is near the middle of the tensioner arm...Hope this
...1996 chevy corsica has a wiper switch that is either slow or really fast would a switch from another 96 corsica that has the delay work with my 96 corsica? I found one at junkyard, dont want to get ...
...tensioner is the smooth pulley(back side of the belt,no grooves)Think it's a 15mm bolt, just "tighten the bolt" and the spring loaded tensioner will move The pulley is steel on the 4 cyl, plastic ...
what transmissions will fit in a 1996 chevy corsica you'll need a corsica trans
...tensioner pulley? Its not the assembly just that 1 pulley loosen of the shaft nut , let the tension of the belt and remove the nut completely the pulley will slide off the shaft remember where the ...
...1996 4 cyclinder chevy corsica ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions