Questions & Answers for: change spark plugs 2001 chevy

...Spark Plugs on 2001 Chevy Blazer How are you supposed to get the plug wires off on a 2001 Blazer to change the plugs? I was able to change the three plugs on the passanger side, but I'm unable to get ...

...change the center sparkplug on 2001 chevy blazer The best possible way to replace the center spark plug or number 3 plug is to jack the front end up so the wheel's are off the ground and go through ...

...spark plugs, wires, oil filter, oil, when put back together car had no power and was missfiring, checked firing order and everything was fine. now it barely goes and is sluggish. change the mass air ...

...spark plug,and maybe swap one plug wire for another to see if the missfire moves to another cylinder. i am assuming you have no test equipment. if that does not change,see if you can get at that ...

...spark plugs and wires on my 2001 Mark, and it was running rough, so I called around and finally spoke to a mechanic, and asked the same question, he must have put me on speaker and requested me to ...

...spark plugs ever been changed? I would rule this out first, as they are inexpensive, and also under more stress than any other part of the ignition system. If the problem persists, then it's time to ...

issue and help would be greatly appreciated. Crank sensor is primarily for the spark and the cam sensor is for fuel management, crank/cam correlation for misfire purposes I would also change the wires

...spark plugs and wires. I put in a new distributor cap, the other one was cracked, and I put a new rotor in. I added a MAS sensor because it would not start unless I poured gas in the carbureator. I ...

...spark plugs rotor button maf sensor and now the crank sensor I still have ruff idle and won't shift from 1st gear can go maybe 20 mph. What else can be the problem. Check the catalytic converter it ...

...2001 Chevy blazer 4.3l and have changed fuel pump fuel filter spark plug wires distributor cap rotor ignition control module battery cables starter and nothing works. What else can be wrong What code ...