roller unit needs to be replaced , Replaced but it is not able to recognise the change Because you have to go into service mode and clear the counter. Utility then meter count then stop00 stop01. then
...roller warm-up failure 1 Check the fusing unit for correct installation (whether it is secured in position). 2 Check the fusing unit, DCPU1, and PRCB for proper connection and correct as necessary. 3 ...
Question about magicolor 2490MF Laser Printer
35-3. what's wrong with it. please help me. Fixing upper roller low temperature error.Verify the continuity the heater lamps and remove and clean the thermofuse.If the thermofuse not working change it
Question about magicolor 2490MF Laser Printer
...each other. Now it wont copy. Please help if you can!!! Check the upper fuser roller and the pressure roller,clean the thermistors and the thermofuses,to reset change the fuser fuse,rapid fuse
...ROLLER. THIS IS AFTER WE GOT THE 17H ERROR MESSAGE. THAT WAS RESOLVED, BUT NOW THE PAPER KEEPS JAMMING. ANY SUGGESTIONS? yes 2 things. 1 bad sensor. 2 bad paper. change paper brand and type. use ...
Question about magicolor 2490MF Laser Printer
...Konica Minolta Copier model no. 7020. A technician changed the drum and used a high powered vacuum to clean the unit afterwards. Verify the fuser ubit components ,mechanical part,the pressure roller ...
...C6500 ERROR CODE 3501 and 3802 but know the error 3501 I know it rech high temperature I change the sensor 1 UP fuser roller and I reset the error, the machine start and stop again with error ...
Question about Bizhub C 6500 Copier
...roller is abnormal high. pl. check the followings. 1-Check the Fusing Unit for correct installation (whether it is secured in position). 2-Check the Fusing Unit, PWB-MC and PU1 for proper connection ...
...roller sensor (PS7) output does not change from H to L. •During a retraction motion being performed, the reverse roller sensor (PS7) output does not change from L to H. Further research yields this ...
...Roller has been started during a warm-up cycle. Remedy 1 Check the Fusing Unit for correct installation (whether it is secured in position). 2 Check the Fusing Unit, PWB-MC and PU1 for proper ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions