oil change and the pressure gauge reads approx. 550 kilopascals. Is this normal? just fixed that problem myself. it was an oil pressure sending unit. twelve dollar part. and i was thinking oil pump or
Question about 1998 S-10 Pickup
...oil sending unit located on a Chevy S10 Pickup. It is a 1998 4 cyclinder 2.2 motor Chevy S10 pickup. We put a new fuel pump on it and it still want start. We were told that if the oil sending unit is ...
oil sending unit I need to know where the oil sending unit is located on my Chevy S10 pickup Hi, It's usually threaded into the bottom of the block near the oil filter, it should have a wire running ...
INSIDE MY 1988 TOYOTA PICKUP MY THERMOSTAT IS NOT READING try changing the sending unit
...oil sending unit is bad may be the oil pump is there any noise in the engine? have the oil pressure check at a repair shop to make sure you have enough oil pressure if it's ok then have the shop ...
oil pressure warning light on, oi level appears ok Possible faulty oil pressure sending unit sending faulty information. Recommend replacing sending unit with a new one and see if that solves it.
...sending unit and that is not the problem. The oil pump pickup can be stopped up. Oil will cook and look like burnt candy. This was the problem on my 91 jetta and could be your problem. I also have a ...
where is my oil pressure sending unit on my 1988 chevy pickup 3/4 ton truck It is located at the very rear top of the engine block behind the intake manifold and just to the side of the distributor.
...oil sending unit, this will take care of the jumping gauge. On the fuel, I would start with replacing the fuel filter, see if this helps. But my first guess on it would be the catalytic converter is ...
...right turn signal indicator light is out on the dash of 1988 chevy s10 pickup. How do I remove the dash to replace the bulbs? ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions