...Montana van. What is the best way to get to the spark plugs to change them. Also my transmission seems to be slipping. Could this be because the filter and fluid needs changed. Slipping tranny can be ...
...change the front plugs easy. Second undo your two front motor mount bolts and rock the van forward to tilt the motor forward as much as you can but dont over do it. Second take all of your coil packs ...
change the intake gasket on a 2000 3.4 My question is, can it be done while th engine is still in the Pontiac Montana mini van? yes it can be done ive done a tonne of those good luck pierre hello, yes
...Montana, front wheel drive. I have a very bad shaking in my van, as if the front end is going to fall off. I have changed the ball joints, tie rod ends, drive shafts, bearings, breaks, rotated my ...
how do you change the rear plugs The best way I have found is to remove the front two motor mounts from the motor, and rock the motor forward, its still not easy but now you can reach back there
...Montana van with a V-6 uses a lot of coolant and there is the smell of burning anti-freeze. It runs very well as of now. my 2000 pontiac has code 420 when on idle is ok on drive or park I step on the ...
...Montana 2000 (but a lot of years sound like they had same problem. My wipers work fine; but when shut off they stop position stuck straight in the air. What can I do about it? (besides changing the ...
...on panel Replace both bolts in arm rest Pop window/door lock control panel back in placeThat is how to change the window motor of the drivers side of a 2000 pontiac montana. Take care and good ...
...van shakes very bad,when you let off throttle it smooths out.Fluid and filter is good/full changed less than 1 yr ago.Tires have been replaced also.Would CV joints be the problem? If it's
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions